Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a bit but it's still attractive. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable driving experience.
We often get asked at Coded Car Keys to replace peugeot key fobs. Whether the problem is intermittent or constant the following tips will help.
Water Damage
If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking, canoeing, rafting or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry bag whenever you are outside or perform activities that could expose it to large amounts of water.
You should also ensure that the fob is dry before opening it up and reusing it. If you detect any smells emanating from the fob such as an industrial-type liquid smell or windshield washer fluid, this is another indication that it's been submerged in water.
A circuit board that is wet could cause the battery to lose its energy or even explode. If you can get your keyfob 308 from the water, turn the button side up and shake as much water out as possible before opening the casing. After opening it, take out the battery and wipe the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system may not work could be due to a dead coin-cell battery or receiver module issues, signal interference or a damaged chip. If none of the above are the cause, you can try resetting the system by disconnection of the 12 volt battery for around 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start systems that allows drivers to start their car from a distance, allowing them to warm up or cool down the car before entering. This feature is extremely useful, especially during winter's cold and chilly months. The remote start system can be stopped for a variety of reasons, such as an inactive coin-battery.
The coin-shaped battery contained within the key fob may last between two and four years, based on how often it's utilized, the place it was purchased, and the way it is utilized. The date of use will be written on the packaging or mentioned in the user manual.
If the key fob stops working after exposure to clean tap water it is recommended to remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If the key fob was exposed to salty or soapy water, it could have fried the chip. You'll need to replace it.
If you're not sure whether the battery is in good condition it is possible to check its voltage with a multimeter that is connected to both the terminals plus and minus. The voltage should read approximately 12-13 volts, however, if it reads lower, the battery should be replaced. If you want to, you can attempt to reset the onboard computer by disconnecting the battery at 12 volts for a couple of minutes, and then reconnecting it in reverse order (positive cable first, then negative). The engine should be able to start after this.
Faulty Receiver Module
If you don't get the "Key Detected" message, it could mean that your receiver module is faulty. It's the part that sends a signal to the car when your key fob is activated which also acts as an immobiliser. It also stops it from starting until the correct key is used.
This could be due to a number of causes including water damage or simply getting old. If your Peugeot 308 key fob has been exposed dirty tap water, as in the electronic chip on the inside will be damaged. In this scenario, you'll have to remove it and thoroughly clean it using isopropyl or an electronic cleaner. Once it's dry you can put the battery back in and test it again.
If the issue persists, it is recommended to visit a local Peugeot expert or locksmith. They can use an instrument for diagnosing to identify the issue and fix it.
The loss of your Peugeot car keys can be an emotional experience. However, a trained auto locksmith can resolve the issue in just a few minutes. They can program your car and cut a fresh, functioning key for you. Click here to locate locksmiths near you.
Faulty Electronic Chip
The electronic chip inside your Peugeot 308 key fob is a very important part of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message saying "anti-theft". In this scenario the only option is to replace the key. peugeot 207 replacement key cost with experience are able to provide this service within the shortest possible time.
The chip inside the key fob of your Peugeot 308 may become faulty for various reasons, including sweat, water damage, or dirt. If your Peugeot 308 key fob has been exposed to soapy water, clean it immediately. You can use a paper towel and isopropyl alcohol to wipe the electronic component. After that, allow the battery to dry completely.
Radio interference can cause the key fob to stop functioning. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects that are in the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you encounter this problem.
The Peugeot Key Fob 207/308 is very delicate and requires particular care. It is imperative not to drop or throw the key fob. If you lose something, try to locate it as soon as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Make sure you disconnect the negative cable first, and then the positive.